Enviro C-11366 Instrukcja Użytkownika Pobierz pdf (Strona 11)

To install the burner:

1. Insert the mixing tube into the mixing

tube box (refer to Figure 8 or 9).

2. When the burner is resting in the

rebox ensure that the front edge of

the burner is lined up with the front

lip of the rebox (see Figure 10 or

11).

3. Re-install the log set or rock set

(see SECONDARY INSTALATION - LOG SET

INSTALLATION or SECONDARY INSTALATION -

ROCK SET INSTALLATION) and the door.

4. Check burner for proper operation.

Figure 11: Align Rock Set Burner With Firebox.

Bring front lip of burner

to front edge of firebox.

Maintenance And Service

Figure 10: Align Log Set Burner With Firebox.

Bring front lip of burner

to front edge of firebox.

FIREBOX BAFFLE REMOVAL:

The rebox bafe can be remove when cleaning the venting pipe.

1. Remove the glass door as shown in the MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL.

2. Remove the two (2) Torx T-20 screws holding the front of the rebox bafe in place (refer to Figure

12). IMPORTANT: The bafe should be held in place when the screws are removed to prevent it from

falling, which could damage the rebox liner, log set, or rock set.

3. Carefully push the back of the bafe up while pulling the front down (see A’s in Figure 13) then pull

the bafe out of the rebox.

4. Re-install the rebox bafe and the door when done.

Figure 13: Firebox Bafe Removal.

Figure 12: Firebox Bafe Screws Removal.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Brak uwag

Enviro C-11366 Instrukcja Użytkownika Strona 11