Enviro Cara Instrukcja Użytkownika Pobierz pdf (Strona 27)

Vent Pipe

Inside Finished Collar

Dry Wall

Wall Thimble

Exterior Wall

Siding

Minimum Vent Terminal 36”

(914mm) High Snorkel Kit.

Figure 46: Installation for Rear Vented;

33,500 Btu/hr.

Place the unit into position.

Attach a small section of pipe on the unit and mark exterior

wall where vent would pass through the wall.

Cut a 10” (25.4 cm) minimum hole in the wall to maintain

clearances to combustibles. Frame hole as shown in Figure

32.

Install a wall thimble, interior nished collar, and the vent

section through the wall.

THIS UNIT MUST BE VENTED WITH A 36” (91 cm) SNORKEL

KIT.

Seal around the vent terminal to the structure using a non-

hardening mastic.

Also refer to

InItIal InstallatIon - Vent ConfIguratIons and

restrICtor settIngs and InItIal InstallatIon - HorIzontal

InstallatIon.

Initial Installation

QUALIFIED INSTALLERS ONLY

conVerting top Vented into rear Vented:

This unit has been shipped as a 33,500 Btu/hr top-vented freestanding unit. This unit can be converted

Figure 45: Converting Top Vented into Rear Vented.

installation of rear Vented appliance:

to a rear vented unit for use with a 36” (915

mm) snorkel. Also refer to InItIal InstallatIon

- InstallatIon of rear Vented applIanCe.

1. Carefully remove the trivet and the

stovetop. Place on a soft surface as not to

damage the nish.

2. Remove the four (4) ¼” screws that hold

the ue collar elbow to the unit body.

3. Carefully remove the elbow being sure not

to damage the gasket that is glued to the

ue collar elbow, it seals the ue to the

rebox (see Figure 42).

4. Turn the elbow 180° to the rear vent

position and re-fasten with the screws

removed in step 2.

Venting

Gasket

Rotate 180

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 45 46

Komentarze do niniejszej Instrukcji

Brak uwag

Enviro Cara Instrukcja Użytkownika Strona 27

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Narzędzia Enviro Cara